The exact order in which you do this will depend on what you are using your Midified DS for, but remember that you can always reconfigure the keymapping later. Now it’s time to start connecting wires from the output pads to the DS buttons. Solder the other end to the pad marked “Green”. This will keep them out of the way while you are connecting the rest of the wires.īend the wire around the edge of the board. The labels on the Midify board are pretty hard to read, so here’s a diagram:īend them under the board as shown. Use the double-sided tape to stick the Midify board to the DS Lite board in the position shown. This will make it easier to attach wires later. Melt a blob of solder onto each pad of the Midify board. Gather all the parts that came with your MIdify kit. Remove the WiFi module from the rest of the board by pulling straight up on it. Place the touch screen back in the top half of the case and set them aside. Remove the remaining screw that is holding the PCB in place.ĭisconnect the black antenna wire from the WiFi module and pull it out from under the Slot-1 assembly.ĭisconnect the white microphone wire from the board.ĭisconnect the small ribbon cable that runs the touch screen by flipping the black part of the connector up and sliding the ribbon out.įlip the board and the bottom LCD up and out of the case.ĭisconnect the two ribbon cable connectors that go to the screens by flipping the dark-gray part of the connectors up and sliding the ribbon out. Remove the L and R buttons, being careful not to lose the pins and small springs that are attached to them. The bottom edge may stick a little, but it just snaps on and off. Lift the back half of the case off of the DS. You will need a Phillips and a tri-wing screwdriver. Remove the screws that hold the back of the case on. Use a knife to pry off the two rubber feet (there are screws underneath).

Use a Phillips screwdriver to remove the battery cover. With the DS Lite upside-down, remove the stylus and the Slot-2 plug. Low-Wattage Soldering Iron with Fine Tip.Here is a step-by-step example of how to install Midify into a Nintendo DS Lite.

How to connect to wps on ds lite